Flasher

Welcome to the C.H.I.P. Pro flasher! It looks like you don't have the C.H.I.P. Flasher app installed in Chrome yet. Click the big [Add to Chrome] button below to get started. While you wait for the app to install, find a paper clip (or jumper wire), a USB cable to connect to C.H.I.P., and the C.H.I.P. you want to flash. Once the app installs, you may choose a flashing image to begin the flashing process. To flash a C.H.I.P. you first need to add the C.H.I.P. Flasher app to Chrome.

First Time setup

Flashing a PocketCHIP? Turn the power off, carefully remove the CHIP, and follow these instructions. Then, when prompted, select the PocketCHIP image.

Connect your CHIP's FEL pin to the GND pin... like this:

Press and hold the small button. You will need to keep it pressed when you plug CHIP Pro into your computer.
Here's a still picture of this
CHIP Pro without Dev Kit?

Keep the FEL button pressed while you connect your CHIP Pro/Dev Kit to your computer using a USB cable. If you are reflashing, you must keep it pressed until NAND detection completes!

Connect your CHIP to your computer using a USB cable.

Connect to your computer using a USB cable
CHIP Pro without Dev Kit?
C.H.I.P. detected Reading details from it . . .‚Äč

Your CHIP details:

Serial #: NAND:
... ...

Choose an image flavor below to start the flashing process.

Flashing will download between 250MB-625MB of data. If you have a slow internet connection, it can take a very long time to finish. If your connection is slow, we recommend that you click on the "cloud" icon in the upper-right corner of the image you want, and download the file first. You can then use the "Choose a file..." option once it's downloaded.

Add to Chrome